Beck Arnley is an industry leader when it comes to genuine foreign nameplate parts.
Since 1914, the company has provided top-notch automotive parts for import cars.
Beck Arnley products boast of outstanding OE form, fit and function.
From Engine Parts to Brake and Chassis components, Beck Arnley has an extensive inventory of auto parts.
You may not be aware of it, but your car is smarter than you think. The engine's computer handles a lot of data, including the temperature of air. To make sure it gets the most accurate temperature reading possible, put in the Beck Arnley Air Temp. Sensor. Your car's engine feeds off a constant mixture of air and fuel. But it doesn't just inhale air and then gulps on fuel, it mixes it. It has a lot to do with the chemistry of air. Under normal conditions, air has low density. Your engine takes this into consideration when deciding how much fuel to pour into the mixture. But instead of measuring air's density, it measures temperature. It then matches the right amount of fuel with air. Ideally, the cooler air is, the more fuel is mixed. This will give your engine the most power under any condition. But if its air temperature sensor is off-target, your car's going to have poor fuel economy. That's why you need the Beck Arnley Air Temp. Sensor. It gives an accurate reading of air temperature to help your engine get the best mix possible. The better the mixture, the more power is produced. And you'll save on gas, too. So if you want enough power to pull you ahead of the pack, but without hurting your fuel budget, get the Beck Arnley Air Temp. Sensor.Most good chefs like to use wine in their cooking. Wine gives food a lot of flavor, especially when cooking meats and sauces. But in order to remove the alcohol, you have to make sure it boils. Otherwise, the alcohol can make you or your friends tipsy over the dinner table. But if you're totally sober and your car still runs wild, you may have a problem of boiling fuel. Better put the Beck Arnley Carb. Heat Shield Gasket under your carburetor. When too much heat builds up in your engine, it could reach the fuel inside your carburetor. Your engine isn't designed to feed on fuel vapors. So once fuel boils because of too much heat, your engine is going to pass out from sudden fuel loss. To prevent excessive heat transfer from your engine to the carburetor, install the Beck Arnley Carb. Heat Shield Gasket. It effectively blocks off heat from the engine. This prevents fuel from boiling to ensure smooth supply to your engine. In fact, it lets in just enough heat to warm fuel up to a temperature ideal for mixing with air. What you get is smoother engine performance and improved fuel economy. So stop letting your fuel boil into the atmosphere with the Beck Arnley Carb. Heat Shield Gasket.If you are into sports, you would know how a bad fall or collision can potentially end a professional athlete's career. No matter how good an athlete you are, it always pays to be a little bit more careful. And the same goes for your car. If it has a torn c.v. boot, replace it immediately with the Beck Arnley C.V. Boot Kit. Otherwise, your wallet's going to be in for a world of hurt. It'll cost you more to buy a new c.v. joint than to replace a damaged c.v. boot. The boot protects the c.v. joint from road dirt and moisture. Once small rocks, sand or pebbles find their way into the joint, and then add water to wash down the lubrication, what you get is a big round pile of useless junk. The affected wheel will not spin with a crushed joint. Better protect it with the Beck Arnley C.V. Boot Kit. Its high-grade rubber material will stand up against the toughest road debris to make sure your c.v. joint is protected for miles to come. It gives an airtight seal to prevent moisture from washing down the lubrication inside the joint. And it can be bought individually to save from buying pairs. Remember, it never hurts to be careful. So if you spot even the smallest tear on your c.v. boots, swap it out quickly with the Beck Arnley C.V. Boot Kit.