Windshield Washer Reservoir
How to Install a Windshield Washer Reservoir in 5 Steps
The windshield washer reservoir equipped on your auto holds the washer fluid until you squirt it on the windshield. You see, it is important to keep this reservoir in good shape; otherwise, you risk compromising your safety, especially when dirt or any other obstruction blocks your view. Over time, the tank may get damaged and punctured, causing the fluid to leak out. Sometimes, patching the part will repair it, but if it is already severely damaged, then you have no option but to install a new one. Here is a five-step guide in installing a new windshield washer reservoir.
Required skill level: Novice
Needed tools and materials
Locating the windshield washer reservoir
Find the location of your windshield washer reservoir through your owner's manual. The part is commonly located under the hood, but it is sometimes accessed through the fender well.
Jacking up the vehicle
Some cars only require you to unscrew the part from above, but other types are accessed from beneath the car. So to install a new one, you will have to jack up the auto. Do not forget to secure it with a jack stand for safety reasons. Once done, remove the right or left front tire of your auto, depending on where the manual says the windshield washer reservoir is located.
Removing the inner fender line
To access the windshield washer reservoir easily, remove the fender line with a screwdriver. The part should have fasteners and screws to facilitate its removal.
Disconnecting the hose, mounting bolts, and tank
Once the fender line is removed, the windshield reservoir should now be accessible. But before removing the part, remember to disconnect the negative cable on the battery and the electrical connector first. Afterwards, unscrew all the leads to the reservoir. This should include the hose and mounting bolt. Once done, remove the damaged reservoir, including the seals.
Assembling the new windshield washer reservoir
After the damaged stock windshield wiper reservoir is removed, screw the new one in place. Do not forget to reattach the hose and replace the mounting bolts and other leads. Afterwards, assemble the electrical connector and battery back in their original setting.