This page is a streamlined version with some content missing. Check out the full version for the complete experience.

How to Replace Front Bumper Cover: 2009-2018 Dodge RAM 1500

Reading Time: 2 minutes

Watch this video to learn how to replace the front bumper cover on a 2009-2018 Dodge RAM 1500.

Replacing Front Bumper Cover on a 2009-2018 Dodge RAM 1500: What You Need

Ready to perform this DIY replacement job? Remember that all the parts in this guide can be found on CarParts.com. Check out all the products that fit your vehicle right here.

Parts Checklist

Front bumper cover

Tightening Torques

There are no tightening torques for this operation.

Tools Checklist

Here’s the toolbox we recommend to repair your Dodge RAM 1500: HM85 85 Piece Ratchet and Socket Set

List of tools:

Fork
Ratchet
10mm socket
8mm socket

The Best Bumper Brands: Reliable Replacements for Your Vehicle See which bumper brands are best for your vehicle. Learn about application, quality, and cost, and find budget-friendly replacement brands. Discover Your Options

Step-by-Step Instructions

Step 1: Vehicle Preparation

Turn off your vehicle’s ignition.
Set the parking brake.
Pull the hood release handle and open the hood.

Step 2: Accessing the Rear Headlight Retaining System

At the mudguard, use a fork to remove the plastic rivet to open the access hatch to the rear headlight retaining system.

Step 3: Front Bumper Cover Removal

To change the front bumper cover, remove the Grille assembly and the two headlights.
Via the access hatch, unscrew the bolt attaching the bumper cover to the fender using a ratchet and a 10 mm socket.
Using a ratchet and an 8 mm socket, loosen the screw attaching the mudguard to the bumper cover.
Perform the same operations on the other side.

Step 4: Disengaging Bumper Cover

Disengage the bumper cover from the fender by pulling it down and out.
On both sides of the bumper cover, pull on the plastic tabs to release the plastic brackets.
Pull on the bumper cover to dislodge it.
Remove the bumper cover.

Step 5: Installing the New Bumper Cover

Set the new bumper cover in place.
Properly position the bumper cover retaining lugs in the fenders, one side at a time.
Reinsert the tabs into their slots to hold the parts together.
Screw the bumper cover retaining bolt back onto the fender.
Screw the mudguard retaining screw back onto the bumper cover.
Perform the same operations on the other side.

Compatible Vehicles

The operation and tools displayed in the video should be available on the following vehicles:

Important Reminders

In order to change the front bumper cover on your vehicle, you need to remove the Grille assembly and the two headlights.

Disclaimer:

This video is for entertainment purposes only. CarParts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area.

Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.