Shipping Update
Select your vehicle

1991 Audi 90 Quattro Camshaft Position Sensor

No refinements found

Shop 1991 Audi 90 Quattro Camshaft Position Sensor

Showing 1 - 1 of 1 results
Sort by:
Camshaft Position Sensor - Sold individually
Part Number: WKP2351536
0 Reviews
Guaranteed to Fit
$71.99
Vehicle Fitment
  • 1991 Audi 90 Quattro 20v 5 Cyl 2.3L Ignition Timing Sensor
Product Details
Quantity Sold : Sold individuallyWarranty : 90-day Walker limited warrantyProp 65 Warning :

Warning SymbolWARNING: This product can expose you to chemical which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

Page 1 of 1 | Showing 1 - 1 of 1 results

Helpful Automotive Resources

P000D Code: Exhaust “B” Camshaft Position Slow Response Bank 2
P000D Code: Exhaust “B” Camshaft Position Slow Response Bank 2Diagnostic trouble code (DTC) P000d stands for “Exhaust ‘B’ Camshaft Position Slow Response.” 
P000B Code: Exhaust “B” Camshaft Position Slow Response (Bank 1)
P000B Code: Exhaust “B” Camshaft Position Slow Response (Bank 1)The code description “B” refers to the exhaust camshaft, while Bank 1 indicates the side of the engine that contains cylinder #1. Note that inline or straight design engines only have one bank. P000B is triggered when the PCM perceives a slow response in the camshaft position phase change from the
P0025 Code: Exhaust (B) Camshaft Position Timing Over-Retarded (Bank 2)
P0025 Code: Exhaust (B) Camshaft Position Timing Over-Retarded (Bank 2)This generic powertrain code may be set in vehicles of varying makes and models. “B” refers to the exhaust camshaft. Bank 2 refers to the part of the engine opposite the bank containing the #1 cylinder.
P0024 Code: Exhaust “B” Camshaft Position- Timing Over-Advanced (Bank 2)
P0024 Code: Exhaust “B” Camshaft Position- Timing Over-Advanced (Bank 2)The VVT system is used in engines to allow better performance and fuel mileage. It adjusts the timing of the camshaft in relation to the crankshaft, thereby altering when the valve’s open and close.
P0019 Code: Crankshaft Position – Camshaft Position Correlation Bank 2 Sensor ‘B’
P0019 Code: Crankshaft Position – Camshaft Position Correlation Bank 2 Sensor ‘B’This code is set when the vehicle’s primary computer (also referred to as the powertrain control module or PCM) perceives that the crankshaft and the bank 2 exhaust camshaft are out of sync.
P0725 Code: Engine Speed Input Circuit
P0725 Code: Engine Speed Input CircuitThis trouble code can also be set if the TCM fails to detect any engine speed signals from the ECM. Code P0725 may be triggered by an electrical or mechanical issue.
Copyright ©2021 CarParts.com, Inc. All Rights Reserved.
Terms of Use
Privacy Policy