Common Indications of a Faulty Chevrolet Tahoe Tire Pressure Sensor
Tire pressure is extremely important to your pickup's drivability. If you are driving your truck with a tire with low air, you might find it hard to turn and control your vehicle. With this, it is crucial to keep track of the pressure in your tire. The tire pressure sensor is the part that helps you do this. Without this sensor, you may end up clueless that one or two of your tires are going low on air. That being said, you need to know when the tire pressure sensor is going bad. Following are some signs you should take note of:
Slow improvement in dashboard warning signal
When your tire pressure is low, the system would alert you through a warning light on your dashboard. Once this happens, you need to attend to your tire before hitting the road again. However, if the warning light continues even after checking and adding air to the tire, there may be an issue with the tire pressure sensor. Check the sensor as it may have low battery already. This weakens the signal that is being relayed to the computer of your truck.
Intermittent warning signal
The tire pressure signal sends information to the system of your pickup through a receiver. If the sensor or receiver is going bad, it may cause intermittent activation of the warning signal for tire pressure. When this happens, you need to check the receiver first as it is the most common culprit for such problem. If the tire pressure receiver is working well, you may check the tire pressure sensor as it may be running low on battery.
Warning signal does not turn off
This is issue is commonly caused by the positioning of the wheels. When you experience this problem where the warning light on the dashboard continues even though the tire has the proper pressure, you need to give your truck a drive. This should significantly increase the pressure received by the Chevrolet Tahoe tire pressure sensor.
Chevrolet Tahoe tire pressure sensor does not send signal
Another common issue with the tire pressure sensor is when it does not send any signal to the receiver. This can be caused by various problems with the sensor. It may be damaged, running low on battery, or not properly reset.