2003-2007 Honda Accord
To on your Accord just follow the steps. You will need to turn off your vehicle’s ignition, remove the glovebox, remove the cabin filter as well as carry out a few other steps. You can carry out this tutorial of 7 chapters in 15 minutes. Take your tutorial and your vacuum and let’s get started!
Duration
15 minutes
Number of steps
7
Difficulty out of 5
1
Average savings
$20
Parts You Will Need
Tools You Will Need
Step-by-Step Installation
Chapter 1:
Turn off your vehicle’s ignition
Step 1/1
Turn your engine off and set the parking brake.
Chapter 2:
Informations
Step 1/1
To access your cabin air filter, you will need to completely open the glove box.
Chapter 3:
Remove the glovebox
Step 1/2
Push the actuator arm located to the right of the glove box to release it from its slot.
Chapter 3:
Step 2/2
Press on each side of the glove box to release the plastic tabs from their slots. Then open the glove box completely.
Chapter 4:
Remove the cabin filter
Step 1/2
Push the two tabs of the filter tray, and pull on them.
Chapter 4:
Step 2/2
Remove the filter from its tray.
Chapter 5:
Clean the filter compartment
Step 1/1
Before putting in the new filter in place, it is important to clean out any impurities or leaves stuck in the filter compartment.
Chapter 6:
Install the new filter
Step 1/4
Take the new filter.
Chapter 6:
Step 2/4
Pay attention to the direction of airflow.
Chapter 6:
Step 3/4
The arrows on the filter should point down.
Chapter 6:
Step 4/4
Place the filter in its tray. Then put the tray back in its slot.
Chapter 7:
Reassemble the glove box
Step 1/3
Close the glove box until the plastic tabs lock.
Chapter 7:
Step 2/3
Clip the actuator arm back into its slot.
Chapter 7:
Step 3/3
Operation complete.
