Watch this video to learn how to replace the air dam/valance on a 2009-2014 Ford F-150.
Replacing Air Dam/Valance on a 2009-2014 Ford F-150: What You Need
Ready to perform this DIY replacement job? Remember that all the parts in this guide can be found on CarParts.com. Check out all the products that fit your vehicle right here.
Parts Checklist
- Lower cover valance
- Penetrating oil
Tightening Torques
There are no tightening torques for this operation.
Tools Checklist
Here’s the toolbox we recommend to repair your Ford F-150: HM85 85 Piece Ratchet and Socket Set
List of tools:
- Ratchet
- 10mm socket
- Needle-nose pliers
- Flat head screwdriver
Step-by-Step Instructions
Step 1: Initial Preparations
- Turn off your engine and engage the parking brake. Pull on the hood release handle and open the hood.
Step 2: Removing the Front Bumper
- To change the lower cover valance, start by removing the front bumper. If desired, for easier access, remove the metal brackets from the front bumper (optional but recommended).
Step 3: Separating the Valance
- Separate the valance from the front bumper. Observe the 15 screws located on the lower cover valance.
Step 4: Removing Valance Screws
- Use a ratchet and a 10mm socket to remove all 15 screws securing the lower cover valance. Spray penetrating oil on the screws to aid in loosening, especially if rusted.
Step 5: Removing License Plate Holder
- Use needle-nose pliers to compress the clips securing the license plate holder, then remove the license plate holder.
Step 6: Detaching Lower Cover Valance
- Similarly, release the two clips holding the lower cover valance on the front bumper.
Step 7: Preparing the New Valance
- Take the new lower cover valance then replace the retaining clips onto the new valance.
Step 8: Reattaching Valance to Bumper
- Reattach the front bumper onto the lower cover valance. Secure the clips to hold the valance in place.
Step 9: Reinstalling License Plate Holder
- Reinstall the license plate holder onto the valance.
Step 10: Screwing Valance and Bumper Together
- Screw back in the 15 screws that connect the front bumper to the lower cover valance. Ensure each screw is properly tightened.
Step 11: Reinstalling Front Bumper
- With the lower cover valance properly secured, proceed to reinstall the front bumper.
Compatible Vehicles
The operation and tools displayed in the video should be available on the following vehicles:
Important Reminders
For easier access to the screws, you can remove the metal brackets from the front bumper.
Don’t hesitate to spray some penetrating oil on these screws as they are typically locked in place by rust.
Disclaimer:
This video is for entertainment purposes only. Carparts.com, Inc. disclaims all damages including, but not limited to, actual, consequential, and/or punitive, for any liability, claim, or any other injury or cause related to or arising from any information or lack thereof posted in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All mechanical car projects entail some risk. It is the sole responsibility of the viewer to assume this risk. If you are in doubt, please consult a licensed mechanic in your area.
Keep Reading: Related Posts
Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.
