CAPA (Certified Automotive Parts Association) is an organization that certifies aftermarket automotive parts to ensure that they meet certain standards for fit, form, and function. CAPA-certified parts are designed to be interchangeable with original equipment manufacturer (OEM) parts, and they are subjected to a battery of tests to ensure their quality. Non-CAPA parts, on the other hand, are not certified by the CAPA organization. These parts may still be of high quality, but there is no independent verification of their quality or compatibility with the vehicle. It's important to note that not all OEM parts are CAPA-certified, and not all non-CAPA parts are of poor quality. However, CAPA certification provides an additional level of assurance that the part will perform as intended. Ultimately, the choice between CAPA and non-CAPA parts will depend on a variety of factors, including cost, availability, and personal preference.

Hello! Yes, these headlights will fit on a 2009 Ford Focus Sedan.

I have a 2009 Ford Focus SE 4-door (Sedan). These lights are an exact fit.

Hi Noah, No, proper headlight adjustment is important when installing new headlights. After installing the headlights, you may need to adjust them. Each headlight must be securely mounted and properly aimed so the beam pattern “cut off line” complies with all applicable regulations.

This may not be a great answer as you should always check your alignment. However I can tell you that I installed these and didn't change the adjustments, months later when I took it in for a required annual VA state safety inspection (and they check headlight alignment) it passed without any adjustment needed.

Hi Izadorra, I'm glad to assist you. The adjustment screws are located on top of the housing. I hope this helps, and if you're interested in these headlights, you can click on the link below for direct ordering to take advantage of our ongoing sale and limited stocks. Happy shopping. https://www.carparts.com/headlight/replacement/set-arbf100109?can=CPAE1047

Yes

Hi Barbara, I'm glad to assist you. No. The fender is not needed to be removed. Please refer to a vehicle-specific service repair manual or a DIY online video-sharing website with car parts install tutorials (e.g., YouTube/Dailymotion). Happy shopping! https://www.carparts.com/headlight/replacement/set-arbf100109?can=CPJE1043_CSQA_20230323

No, after removing two screws just pull straight out. It is tight, but you don't need to remove the finder.

No. I replaced both headlights from the engine compartment.

No, I didn’t have to remove the fender.

no