Hi Kyle, The variable valve timing solenoid is located at the front of the engine, typically near the front of the valve cover. Try looking at the solenoid to match the shape. The connector is the exposed end of the variable valve timing solenoid.

Hi Will, I am pleased to assist you. When replacing a variable timing solenoid, the gasket's placement depends on the specific design of your vehicle's engine. It typically installs without removing the valve cover. The gasket or o-ring sits flush against the engine surface, sealing the solenoid in place. To install, simply locate the old solenoid, disconnect the electrical connector, and remove the mounting bolts. After cleaning the seating area, insert the new solenoid with the gasket properly aligned, secure it with bolts, and reconnect the wiring. Once installed, start the engine and check for leaks to ensure a proper seal. If your vehicle information matches this product, use the link below to order while the part is in stock. I hope this helps, and enjoy shopping! https://www.carparts.com/variable-timing-solenoid/replacement/repf380801?can=CPGG4850_CSQA_20250312

Hi Ormond, I'm pleased to assist you. Yes, it will come with a new screw and gasket as shown in the product picture. Use the link below to place your order directly while supplies last. I hope this helps, and happy shopping! https://www.carparts.com/variable-timing-solenoid/replacement/repf380801?can=CPGG4850_CSQA_20231020

There are currently no answers for this question.