Signs That Your Mercedes Benz 190d Brake Pad Set Has Gone Bad
Your car's engine is important in keeping your vehicle in motion, but the brake pads are essential in making sure that your car stops when it should. Your Mercedes Benz 190d brake pad set is efficient in keeping you and other people safe on the road. However, it has its limitations. Here are some problems you might have with your brake pad set and what you should do about it:
Car goes too far before stopping
When trying to reduce speed, you feel that the brakes have become weak. No matter how hard you step down on the pedals, you feel very little grip and your vehicle travels far before stopping completely. This problem might be due to worn-out brake pads on your car. Exhausted brake pads do not offer sufficient grip, which is very dangerous especially when there are plenty of pedestrians or motorists on the road. If you feel the pedals have become squishy, check your brake pads for signs of wear and tear. Brake pads easily wear out when they overheat-an incident that is very common among brake pads of cheaper quality.
Vibration upon braking could be due to a number of reasons. It could be due to warped rotors or bad brake calipers. However, the most common culprit for this is worn-out brake pads. If you've ruled out the other possible causes, check if the brake pads have thinned out. Replace used-up brake pads, as they are no longer efficient in providing friction upon braking.
The squeaking sound you hear upon braking is a warning that your brake pads might be worn out. Most brake pads come with a wear indicator that produces a high-pitched noise when you drive your vehicle at low speed. Check your brake pads for signs of wearing out-if you notice that the groove at the center of the pads is tattered (even if not all the way through), you need to remove the old brake pads and replace them with new ones.
Vehicle pulls to one side
There are two reasons why vehicles would pull to one side upon braking: damaged brake disc or bad brake pads. If you've ruled out a brake disc problem and the pulling issue still exists, it might be a good idea to replace your brake pads with a high-quality pair. This helps your vehicle brake evenly and smoothly.
Three Ways to Make Your Mercedes Benz 190d Brake Pad Set Last Longer
Your Mercedes Benz 190d brake pad set is designed to keep you safe on the road by providing excellent braking power to your vehicle. Although it's made to last your vehicle thousands of miles, the brake pads wear out over time-they do so more quickly if you don't drive conscientiously. To make your brake pad set last longer, you can follow the simple maintenance tips below:
Regularly check your brake pads for signs of wear and tear.
Brake pads don't wear out without any warning. Before you even lose your brakes, you'll notice a few signs (a squealing noise, light on the dashboard, or change in brake feel) that indicate the need for a brake pad set replacement. It's recommended that you replace your car's brake pads once you observe the early signs of wear. This ensures that you don't get into the road with a faulty braking system. Moreover, replacing the brake pad set is much less expensive than getting a new rotor installed or getting your car fixed after a collision.
Avoid hard braking.
Driving at high speed and killing the pace instantaneously by hard braking can do a lot of damage on your brake pads. The pads could overheat, and you'll be left with spongy brakes that offer very little stopping power to your vehicle. To avoid thinning out your brake pads way too early, you need to learn the art of coasting-that is, reducing your car's speed to a decent velocity until it's time for you to make a complete stop. Not only is this beneficial to prolonging the efficiency of your brake pads, but it is also important for your and other people's safety.
Put your foot on the brake only when necessary.
A lot of drivers are guilty of braking unnecessarily. That puts the pedals and the brake pads into a lot of pressure, making them prone to early wear and tear. Additionally, do not step on the brake pedal if your other foot is still on the accelerator. Doing so will put the brake pads under a lot of pressure, and that makes them wear out faster than they should.