How to Change a Damaged Early Fuel Evaporator in Twelve Easy Steps
The early fuel evaporator is a part of your vehicle's internal combustion system. Its main function is to vaporize the fuel before it goes into the intake manifold and reduce the toxic byproducts released by the engine. Just like every other parts of your car, this component can also get damaged due to overuse or lack of maintenance. You won't be getting maximum power from your engine once the early fuel evaporator breaks down. If you want to keep your vehicle performing optimally, then you should replace a damaged early fuel evaporator right away. Here are the steps for this task:
Difficulty level: Moderate
What you'll need:
- Ratchet and socket set
- Putty knife
- Owner's manual
- Replacement early fuel evaporator
- Clean rags
Step 1: Park your car on a well-lit area to ensure that you properly see the components that you need to remove later. You should also keep well away from combustible materials and flames.
Step 2: Raise the hood of your vehicle and find its battery. You need to disconnect the negative battery cable to ensure that you're safe from electric shocks while you're dealing with the other parts of your car. You should wrap a clean rag around the tip of the cable to keep it from coming into contact with other metal components.
Step 3: Take the air cleaner assembly off your car and set it aside.
Step 4: In order to access the early fuel evaporator, you need to remove the carburetor first. Begin by disconnecting the electrical wirings and vacuum and fuel hoses that are attached to the carburetor.
Step 5: Using the right set of hand tools, remove the fasteners that are used to secure the carburetor in place. Place them on an organized area so it would be easier for you to find them later when you're reinstalling the carburetor.
Step 6: After you've removed the carburetor, you should now be able to see the damaged early fuel evaporator of your vehicle. Unplug all the components that are attached to it.
Step 7: Pull off the faulty early fuel evaporator. While you're doing this step, it's also recommended that you check the gaskets and heat insulation blocks around the system to see if they're still in good working condition. If you find a worn-out component, consider replacing it as well to keep the entire combustion system in good shape.
Step 8: Clean the gasket using your putty knife before you install the new early fuel evaporator. Make sure that you prevent debris from falling into the engine.
Step 9: Place the replacement early fuel evaporator over the intake manifold. Don't forget to double-check its alignment.
Step 10: Reinstall the carburetor over the intake manifold. Tighten up the fasteners properly to avoid complications.
Step 11: Connect the electrical wirings back to the carburetor and early fuel evaporator.
Step 12: Reattach the air cleaner assembly and negative battery cable. After you do so, turn the engine on and test if the new early fuel evaporator is operating properly.
This entire procedure may take almost one hour to finish. Don't forget to observe proper safety precautions!