Window Gear Replacement: How to Get It Done in a Few Easy Steps
Raising or lowering your car's window is one of the simplest tasks that you take advantage of every time you ride your vehicle. One of the mechanisms responsible for making this easier for you to do is the window gear. However, this component is also bound to deteriorate after some time, especially if it's not properly maintained. A broken window gear may cause your vehicle's window to get stuck. Once you find yourself in this situation, make sure that you replace the window gear immediately. To help you out, here are the steps that you need to do:
Difficulty level: Easy
What you'll need:
- Socket set
- New window gear
- White lithium grease
- Masking tape
Step 1: Raise the hood of your car and find its battery. It's a good rule of thumb to disconnect the negative battery cable before proceeding with the removal or installation of any automotive component that's connected to the electrical system of the vehicle.
Step 2: Roll the window all the way up to make the replacement procedure easier.
Step 3: Remove the door panel of your car. You may need to unfasten the screws that are securing it using a screwdriver. The other components that you need to take off in order to access the window gear depend on the type of window that you have. Make sure that you place all the screws and clips on an organized area to keep them from going missing. It's also recommended that you read your owner's manual to get specific instructions that would help you finish this step properly.
Step 4: Once you have the door panel removed, put masking tape on the window glass to ensure that it stays up while you're working on the window's mechanical components.
Step 5: Disconnect the electrical wirings that are attached to the window motor.
Step 6: Using a wrench, remove the bolts that are securing the window regulator in place. Taking the window regulator off its mounting location makes it easier for you to access the window gear.
Step 7: Once you have the window regulator out, remove all the components that are hindering your access to the gear. Be extra careful when doing this step! You wouldn't want to cause bigger damage on any of the regulator's components.
Step 8: Detach the old window gear from the regulator and put its replacement in place.
Step 9: Reattach all the components that you removed from the regulator before bolting it back into the window assembly.
Step 10: Apply ample amount of white lithium grease to the mechanical parts of the window assembly. Be careful not to get any of it on the window glass.
Step 11: Put the door panel back and secure it using the screws that you previously removed. Don't forget to plug the negative battery cable back after you're done working on your car's window.
Step 12: Test if the new window gear is working by rolling your window up and down for a few times. Its movement should be smooth.
The easy task of replacing a window gear may take approximately one hour to finish even if you're just a novice DIYer.