Select your vehicle
Refine by:

Battery Cable End

Showing 1 - 2 of 2 results
Sort by:
AC Delco 92199462 Battery Cable End - Direct Fit
AC Delco®
Part Number: AC92199462
Vehicle Info Required to Guarantee Fit
$38.04
Product Details
Notes : Ring Terminal TypeWarranty : 24-months or unlimited mile AC Delco limited warrantyAnticipated Ship Out Time : Same day - 1 business dayQuantity Sold : Sold individually
AC Delco 92199463 Battery Cable End - Direct Fit
AC Delco®
Part Number: AC92199463
Vehicle Info Required to Guarantee Fit
$42.70
Product Details
Notes : Ring Terminal TypeWarranty : 24-months or unlimited mile AC Delco limited warrantyAnticipated Ship Out Time : Same day - 1 business dayQuantity Sold : Sold individually
Page 1 of 1 | Showing 1 - 2 of 2 results

Battery Cable End Guides

Replacing your Battery Cable End

Thanks to your battery, you're able to listen to your radio, make use of your headlights, and get your car started. Automobile batteries are very vital components; however, they seem to be their own worst enemies. Why? Because most batteries, which are lead-acid secondary cells, give off sulfuric acid vapors while the battery is being charged. Over time, these vapors can corrode the battery connectors and damage them. In the event that this happens, the battery cable ends will call for replacements. Fortunately for you, changing out your battery cable ends should be a no sweat DIY task.

Difficulty Level: Easy

Things you will need:

  • Safety gloves
  • Battery cable
  • Slip-joint pliers
  • Wire cutters
  • Utility knife or razor
  • Soldering iron
  • Electronic solder
  • Replacement battery cable ends

Step 1: When doing DIY repair jobs, especially electrical ones, be sure to wear safety gloves before getting started.

Step 2: Raise your hood and keep it propped open.

Step 3: Loosen the battery cable retaining nut. Remove the cable from the battery post. Cut the old battery cable using a knife or razor and remove half an inch of insulation from the snipped wire.

Step 4: Take your new battery cable end and loosen its top bolts. Insert the stripped end of the battery cable in the space created when loosening the top bolts. Then tighten the bolts until the connector securely holds the cable.

Step 5: Solder the wire to the terminal connector.

Step 6: Loosen the battery terminal retaining nut, and position the new battery cable end over the battery post.

Step 7: Tighten the nut until the connector firmly clamps the battery post.

Step 8: At this point, you're abut all set. Just close your hood and test out if the battery works by starting your engine.

Warning!

Do not attempt to replace cable ends when one terminal is still connected to the battery. Doing this may result in electrocution.

Copyright ©2020 Carparts.com. All Rights Reserved.
Terms of UsePrivacy Policy