Keeping Your Pontiac Firebird Dash Cover Clean
Even though the classic GM performance marque has taken its final bow, many are still seen driving Pontiacs around. These cars have established themselves as the quicker variants among the General Motors line. The same can be said of the Screaming Chicken. Enthusiasts still try to emulate the Smokey and the Bandit persona with their cars. You have souped up Trans Am V8s and fierce paint schemes for the performance feel. But you also have the Pontiac Firebird dash cover to provide a homier atmosphere in the cockpit. So that you can keep that homey yet competitive ambience inside, you should know how to take care of that accessory. Here are some tips on how to keep your dash cover clean.
- Eliminate dust particles with your brush and vacuum cleaner.
One of the first steps you have to take in dash cover cleanliness 101 is getting rid of the dust particles. You should have your dash cover get acquainted with your brush and vacuum cleaner. These guys are your frontline defense against dust. Use the brush to loosen the layers of dust on the cover. Follow it up with your vacuum cleaner. Gently swipe the nozzle left and right to cover the entire dashboard. By this time, you have reduced the amount of dry particles lying on the surface of your cover.
- Can your adhesives still hold the cover together?
You have to ask yourself if the adhesives are still ok to hold your dash cover well. Keeping the adhesive tapes in check can prevent unnecessary movement and wrinkling of the cover. If you have noticed that the tapes are getting ineffective, then you might as well replace them with new ones.
- Use the compatible detergent for thorough cleaning.
If you end up having to wash your dash cover to bring back its character, then you do so using the compatible detergent for the material. Having the right formula for your fabric ensures that the ingredients can properly clean your cover without leaving unwanted stains. Choose your products carefully for best results.
Tips to Install the Pontiac Firebird Dash Cover Easily
Imagine having Burt Reynolds ride shotgun with you in a wonderfully restored Trans Am. My goodness, you are living your Smokey and the Bandit pursuits. You take the car for a spirited run along the mountain side and through country roads. It must be so close to the movie itself. But as Burt was sipping his soda and munching on a burger, a moose suddenly crossed the road. You had to slam the brakes hard to avoid a road kill. The food and drink spilled over your entire dashboard. It was a huge mess. Oh, what a terrible, terrible mess! Then Burt started whispering to your ear, "It's ok honey. It's all a bad dream." You opened your eyes and jumped out of the bed. Phew. But by this time, you realize the need to put a protective layer for your panel. So what about installing a Pontiac Firebird dash cover? Sounds like a good idea. Here are some tips on how to do so.
Tip #1: Clear out the old cover from the panel.
Like what the physics say, two objects can't occupy the same space at the same time. This is why you should clear out the old cover from your dashboard. Ok, your lazy side is telling you to take the shortcut and just mount the new cover on the old. Don't! Having two layers of dash cover on top of one another will make it very bulky. Besides, the stench and all the other elements will end up being sealed under the new dash cover. Don't think twice. Remove the old cover first.
Tip #2: Eliminate the residue old adhesive tapes. Scrub if needed.
The old dash cover stayed in its place because with the help of adhesive tapes. After clearing out the old cover, take note of the spots where the tapes used to hold the cover. Carefully remove the tapes from their places. Scrub the surface using a moist cloth if needed. The goal is to make the dashboard smooth and tidy again before placing the new cover.
Tip #3: Test fit the cover before mounting it for good.
After preparing your dashboard for the new cover, you're almost set to go. But before you mount the dash cover in place, do a test fit. Make sure that its dimensions match your panel.