Five Easy Steps to Replace Your Strut Tower Repair Cap
So you've been experiencing wobbly rides whenever you drive in highways. Upon checking, you found out that your vehicle's strut towers were already worn out. You saw that the culprit is nothing but rust. The strut towers help stabilize the movement of your vehicle, especially when you are driving in high speeds. Due to age and frequent use, it is inevitable that your vehicle's strut towers will succumb to premature wear. When this happens, it is important that you take time to replace it. You might think that the only way to fix your strut towers, but did you know that adding a strut tower repair cap can do the trick? Don't worry about having to spend a few dollars to get it done by your trusty mechanic; you can install the cap on your own. All you need to do is to arm yourself with the right tools, and follow these five simple steps.
Difficulty level: Easy
What you'll need:
- Pop rivets or adhesive
- Powder coating paint
- Replacement strut tower repair cap
- Replacement strut towers (optional)
Step 1: Refer to your vehicle's owner's manual to locate the position of your strut towers. Usually it can be found in the middle of the fender area. The location of the towers makes it prone to rust, that's why it is important to check their condition regularly.
Step 2: If your strut towers are already covered with rust all over, you need to replace them to ensure optimum performance. Remove your rusted stock strut towers, and replace them with new ones. If they are still in good condition, then proceed to the next step.
Step 3: Next, install your replacement strut tower repair cap on top of the strut tower. You can use either pop rivets or a power adhesive to affix it. Note that adhesive is more expensive than pop rivets though.
Step 4: Tighten the cap in place, and if possible, weld it to ensure that it is intact. Make sure that it will not easily give in because it could go missing while you are driving.
Step 5: Once installed, give your strut tower repair cap a generous amount of powder coating. The powder coating will keep it protected from external factors. This will result in an almost permanent paint job to keep it as natural and as durable as possible.
Although this easy fix has been criticized because it only involves a cap to reinforce the perimeter of the tower, it has been proven an effective and inexpensive repair. All you need is the cap and the necessary pop rivets. You can purchase a kit for as low as $15 to $20 per piece. You can do the installation for free, and it will take you less than 30 minutes to get the job done. To keep this from happening again, take time to check the condition of your strut towers at least once a year, and replace the cap with a new one if it wears out.