Replacing a single brake caliper usually costs $119 to $213 for parts and labor, according to Jerry‘s repair data updated November 17, 2026, though RepairPal‘s national average comes in much higher at $898 to $968, with about $749 of that in parts (updated September 3, 2026). The two figures do not itemize the same work: RepairPal’s procedure also calls for new pads on both sides of the axle and bleeding the entire brake system. Your own price will depend on the type of caliper your vehicle uses, whether it sits in the front or rear, and what other brake work goes on the bill. This guide walks through each of those cost factors, when replacing calipers in pairs makes sense, how to tell whether the caliper is really the problem, and ways to keep the repair affordable.
How Much Does a Brake Caliper Replacement Cost?
The two most-cited estimates are far apart, and they do not itemize the same work. Both describe replacing a single caliper. RepairPal’s procedure also calls for new pads on both sides of the axle, rotors if needed, and bleeding the entire brake system.
| Source | Scope | Parts | Labor | Total |
|---|---|---|---|---|
| Jerry | One caliper | Not split out | Not split out | $119 to $213 |
| RepairPal (national average) | One caliper plus pads on both sides | About $749 | $150 to $219 | $898 to $968 |
RepairPal’s vehicle estimates also vary widely. It lists $470 to $539 for a Ford F-150, $521 to $589 for a Toyota Camry, $705 to $772 for a Honda Civic and $1,461 to $1,530 for a Nissan Altima.

Why Do Brake Caliper Prices Vary So Much?
Four factors drive most of the difference between quotes: the type of caliper, whether it is a rear caliper with an electronic parking brake, how long the labor takes, and what related parts and service go on the same bill.
The Type of Caliper
Remanufactured floating calipers are the lowest-cost option in Jerry‘s price list, and fixed multi-piston performance calipers are the most expensive, as the table below shows.
| Caliper type | Part price (each) |
|---|---|
| Remanufactured floating caliper | $70 to $180 |
| New OE caliper | $150 to $400 or more |
| High-performance or fixed multi-piston caliper | $400 to $1,000 or more |

Front, Rear and Electronic Parking Brakes
Rear calipers on many newer vehicles have an electronic parking brake built in. Brake & Front End says a brake job on these vehicles requires a scan tool with the right software to retract the calipers. Some models have a manual release procedure, but on GM vehicles, for example, a scan tool is the preferred method. Jerry estimates that electronic parking brake rears add $150 to $400 to the job because of the part cost and procedure, plus $20 to $80 if scan-tool steps are needed.

Labor and Rust
Jerry puts labor at 1.0 to 1.8 hours per caliper. Rusted bolts, seized bleeder screws or rounded fittings can add 0.5 to 1.0 hour.
Related Parts and Service
A caliper is rarely the only line on the bill. These are the most common add-ons and what each typically costs.
| Related work | Typical cost |
|---|---|
| Pads and rotors (per axle) | $322 to $586 |
| Bleeding the opened brake circuit | $70 to $150 |
| Full brake fluid flush | $90 to $180 |
| Slide pin service or hardware kit | $80 to $150 |
| Brake hose (installed) | $116 to $145 |
For more on the pad and fluid side, see our guides to brake pad replacement cost and brake fluid replacement cost.
Do You Need to Replace Brake Calipers in Pairs?
It is common practice, though not always required. PowerStop says replacing calipers in pairs is generally considered good practice for balanced braking, and both calipers on an axle see similar wear. Brake & Front End adds that replacing just one is acceptable if the other caliper is healthy, as long as the pads on the other side are replaced too.
The tradeoff is cost. Jerry says doing both sides roughly doubles the parts cost, while the shared labor saves about $40 to $80 compared with two separate jobs.

Is the Caliper Really the Problem?
PowerStop lists the common signs of a failing caliper: uneven pad wear, fluid leaks around the caliper, pulling to one side when braking, a dragging feeling, reduced stopping power, noise, and a piston that does not retract. Our guide to bad brake caliper symptoms covers each one, and why a brake caliper sticks explains the most common failure.
Some of these problems can be fixed without a new caliper. Brake & Front End notes that wear on the outer pad often points to slides or mounting pins that are not working properly. If the caliper body and piston are sound, a guide pin or hardware service may be all you need. Jerry lists that service at $80 to $150, which can be less than a new caliper on the same vehicle.
Warning: A leaking or dragging caliper reduces braking performance. Have it inspected before you keep driving, and check NHTSA for open recalls on your vehicle, since recall repairs are free at the dealer.
Can You Replace a Brake Caliper Yourself?
You can if you have experience with hydraulic brake systems. RepairPal recommends professional service, but says a DIYer with that experience could do the job. The steps are in our guide on how to replace a brake caliper. Keep the following points in mind before you start.
- Plan to bleed the brakes. Opening the system lets air in. Our guide on how to bleed brakes covers the process.
- Flush old fluid first. Brake & Front End recommends flushing the brake fluid before installing a new caliper, so contaminated fluid does not reach the new seals.
- Check for an electronic parking brake. Rear calipers with one usually need a scan tool to put the system in service mode before you retract the piston.
- Consider a shop for fixed calipers. Jerry recommends a shop for fixed multi-piston calipers.

How Can You Lower the Cost?
- Confirm the caliper has failed. Seized slide pins or worn hardware can cause similar symptoms, and servicing them may be enough.
- Choose remanufactured for a daily driver. Jerry describes remanufactured calipers as the smart value for most commuters. Return the old caliper to get the core charge back.
- Replace pads at the same visit. RepairPal says pads are replaced with the caliper, so pair the job with a pad set or a pad and rotor kit if the rotors are worn.
- Do both sides together when the other caliper is aging. The shared labor costs less than a second visit later.
- Check for recalls. A recall repair costs nothing at the dealer.
FAQs
Jerry says most drivers pay $119 to $213 for one caliper, parts and labor included. Electronic parking brake rears and fixed performance calipers cost more.
Yes. Replacing a caliper opens the hydraulic system, and RepairPal lists bleeding as part of the replacement process. Jerry estimates $70 to $150 for bleeding the opened circuit.
For most commuter cars, a quality remanufactured caliper is a sound choice. Jerry describes remanufactured units as the smart value and suggests new OE calipers for late-model luxury or performance cars under warranty, or when remanufactured units are not available.
There is no fixed interval. eBay Motors says calipers are commonly replaced every 75,000 to 100,000 miles, but heat, corrosion and road salt can shorten that.
High quotes often include more than the caliper itself. RepairPal‘s national average of $898 to $968 assumes new pads on both sides and a full bleed, and an electronic parking brake or fixed performance caliper adds more. Ask the shop for an itemized quote so you can see each part and the labor hours.
Any information provided on this Website is for informational purposes only and is not intended to replace consultation with a professional mechanic. The accuracy and timeliness of the information may change from the time of publication.






